Eyewash and Shower Equipment
Eyewash and Shower Equipment
Viewing Page 14 of 38
(371 results)
HAW 6424
Items #:
HAW 6424
Model 6424 Brita® Hydration Station® replacement filter cartridge is used on models 2000 and 2000SM systems which are tested and certified by CSA International against NSF/ANSI Standard 42 for the reduction of chlorine (taste and odor) and against NSF/ANSI Standard 53 for the reduction of lead and cysts. It is a 2,500 gallon (9463 L) capacity carbon block filter cartridge.
HAW 6425
Items #:
HAW 6425
Haws model 6425 Activated Carbon granule filter removes chlorine taste and odor, and water born sediment. Polypropylene filter housing is 2" (5.1 cm) in diameter by 6" (15.2 cm) long, 3/8" NPTF inlet and outlet. Rated for .5 gpm (1.9 L), this filter protects the water flow for one bubbler, two filters are required for Hi-Low, dual-height or multi-bubbler drinking fountains.
Haws manufactures drinking fountains and electric water coolers to be lead-free by all known definitions including ANSI/NSF Standard 61, Section 9, California Proposition 65 and the Federal Safe Drinking Water Act.
HAW 6426
Items #:
HAW 6426
Model 6426 is a lead removal 12" x 2" (30.5 x 5.1 cm) in-line filter with 1/4" NPTF inlet and outlet. Reduces lead from incoming water to levels below 15 ppb (@ flow rate = 0.5 gpm (1.3 L); pressure = 60 psi (4.2 bar)) for up to 500 gallons (1893 L). Filters particulate lead to 10 microns and absorbs soluble lead. Maximum flow of .5 gpm (1.9 L). Therefore, only 1 bubbler may be operated at a time on dual units. Does not leach lead once absorbed. Performance demonstrated under NSF Standard 53 and 42 by independent, certified testing laboratory.
Haws manufactures drinking fountains and electric water coolers to be lead-free by all known definitions including NSF/ANSI Standard 61, Section 9, California Proposition 65 and the Federal Safe Drinking Water Act.
HAW 6454
Items #:
HAW 6454
Model 6454 is a polished chrome-plated solid brass flat waste strainer with vandal-resistant locking lugs, washer, locknut and slipjoint tailpiece. Dimensions: flange dia, 2-1/2" (6.3 cm) fits 2" (5.1 cm) drain hole; 1-1/2" O.D. (3.8 cm) slipjoint tailpiece x 1-1/2" (3.8 cm) long.