Search in Category
Calibration Gas and Accessories
Search term required.
Search Filters
-
Draeger, Inc. x
Filter Your Search
Browse Categories
Loading...
Calibration Gas and Accessories
There are a number of reasons why you would need calibration gas and accessories, especially if you’re working in an industry that requires the collaboration of certain gases. The key is not only getting the best quality equipment in the industry, it’s also about using it properly. Safeware provides the education and training equipment needed to safely operate and use the calibration gas and accessory equipment we have in stock. Shop our online selection here.
Viewing Page 1 of 1
(7 results)
DRA 4594655
Items #:
DRA 4594655
Draeger calibration gas for standard 4-gas monitors. Designed for use with bump test stations and gas detection instruments including the X-am2000 and X-am 2500.
Gas mixture for this cylinder is 50% LEL CH4 (methane), 100 ppm CO (carbon monoxide), 25 ppm H2S (hydrogen sulfide), and 17%VOL O2 (oxygen). Total capacity of this aluminum canister is 58L.
DRA 4594632
Items #:
DRA 4594632
Draeger equivalent 100 ppm Carbon Monoxide (CO) bump gas cylinder used to test sensors in Draeger gas detection equipment with carbon monoxide gas sensors.Fully compatible with Draeger gas detectors requiring 100 ppm carbon monoxide with balance air.Precision blended and inspected to industry standards - National
Institute of Standards and Technology (NIST) traceable and certified.Made in the USA by GASCO, ISO 9001:2008 Certified.
DRA 4594645
Items #:
DRA 4594645
Draeger equivalent 100 ppm Ethylene (C2H4) span gas cylinder used to calibrate Draeger gas detection equipment with ethylene gas sensors.Fully compatible with Draeger gas detectors requiring 100 ppm ethylene with balance air.Precision blended and inspected to industry standards - National Institute of Standards and Technology (NIST) traceable and certified.Made in the USA by GASCO, ISO 9001:2008 Certified.
DRA 4597057
Items #:
DRA 4597057
Draeger equivalent 0.5 ppm Phosphine (PH3) span gas cylinder used to calibrate Draeger gas detection equipment with phosphine gas
sensors.Fully compatible with Draeger gas detectors requiring 0.5 ppm phosphine with balance nitrogen.Precision blended and inspected to industry standards - National Institute of Standards and Technology (NIST) traceable and certified.Made in the USA by GASCO, ISO 9001:2008 Certified.